dls

Use the dls command to enable or disable DLS (HiPath Deployment Services). The dls command is available from the topology:<named-topology>:l3:dhcp context of the CLI for b@ac and routed topologies. This command is visible only when mode is set to local. See mode.

After you run the dls command, run the apply command to implement the changes.

dls enable | disable

Parameters

enable Enables DLS.
disable Disables DLS.

Examples

The following example enables DLS:

EWC.extremenetworks.com:topology:test:l3:dhcp# mode local
EWC.extremenetworks.com:topology:test:l3:dhcp# dls enable

The following example disables DLS:

EWC.extremenetworks.com:topology:test:l3:dhcp# mode local
EWC.extremenetworks.com:topology:test:l3:dhcp# dls disable