radio1-strictlimit

Use the radio1-strictlimit command to enable or disable strict enforcement of hard load limits on Radio1 when Radio Load Control is active. When strict limit is enabled, any clients in excess of the configured limits on the radio are immediately disconnected. The radio1-strictlimit command is accessible from the ap:load-groups:<named-loadgroup> context.

radio1-strictlimit enable | disable

Parameters

enable | disable Enables or disables the strict enforcement of load limits on Radio1.

Usage

Radio Load Control must be enabled for this radio before this command can take effect.

Example

The following example enables strict load limiting on Radio1:

EWC.extremenetworks.com:ap:load-groups:radiogroup1# radio1-strictlimit enable