vsa-ap

Use the vsa-ap command to include AP Identification in the message to the RADIUS server. The vsa-ap command is accessible from the wlan:<WLAN-service-name>:auth context of the CLI.

After you run the vsa-ap command, run the apply command to implement the changes.

vsa-ap enable | disable

Parameters

enable | disable Enables or disables the inclusion of AP Identification information in messages to the RADIUS server.

Usage

The vsa-ap command is not available when the authentication mode is guestportal. When the authentication mode is disabled, MAC must be enabled for this command to be available. For more information, see mode.

Example

The following example enables the inclusion of AP Identification information in messages to the RADIUS server:

EWC.extremenetworks.com:wlans:test:auth# vsa-ap enable
EWC.extremenetworks.com:wlans:test:auth# apply
EWC.extremenetworks.com:wlans:test:auth# show vsa-ap
AP as VSA attribute: enable