l3

Use the l3 command to enter the topology:<named-topology>:l3 context of the CLI for Admin, b@ac, b@ap, physical, and routed topologies. The l3 context allows you to configure the Layer 3 functions of the topology. The l3 context is now available in b@ac mode when l3presence is set to disable. For more information, see l3presence.

The following commands are available in the topology:<named-topology>:l3 context.

• ap-register
• cert
• copy-csr
• dhcp — See dhcp for commands in the topology:<named-topology>:l3: dhcp context.
• exceptions — See exceptions for commands in the topology:<named-topology>:l3:exceptions context.
• foreign-ip
• gateway
• gateway-ipv6
• gen-certreq
• ip
• ipv6
• mgmt
• mtu
• netmask for named toplogies with disabled l3presence. See l3presence.
• nexthop
• ospf-advert
• ospf-cost
• show