apip

Use the apip command when statically configuring a Wireless AP. In order to statically configure a Wireless AP, you must first run the no usedhcp command. The apip command is accessible from the ap:<serial> context of the CLI.

apip IP Address netmask
[no] apip xxx.xxx.xxx.xxx xxx.xxx.xxx.xxx

Parameters

IP Address IP address of the Wireless AP
netmask Netmask of the of the Wireless AP

Example

EWC.extremenetworks.com:ap:7000001222222222 apip 10.205.3.131 255.255.255.0