wpa-v1

Use the wpa-v1 command to configure the WPA v1 encryption protocol. The wpa-v1 command is accessible from the wlan:<WLAN-service-name>:priv context of the CLI.

After yourun the wpa-v1 command, run the apply command to implement the name change.

wpa-v1 auto | tkip | none

Parameters

auto | tkip | none Specifies the WPA v1 encryption protocol

Usage

The wpa-v1 command is available when the privacy mode is set to wpa or wpa-psk. For more information, see mode.

Example

The following example displays the WPA v1 encryption protocol, sets the WPA v1 encryption protocol to TKIP, and displays the setting:

EWC.extremenetworks.com:wlans:test:priv# show wpa-v1
WPA v.1 encryption is not enabled
EWC.extremenetworks.com:wlans:test:priv# wpa-v1 tkip
EWC.extremenetworks.com:wlans:test:priv# apply
EWC.extremenetworks.com:wlans:test:priv# show wpa-v1
WPA v.1 encryption: