vsa-topology

Use the vsa-topology command to include topology information in the message to the RADIUS server. The vsa-topology command is accessible from the wlan:<WLAN-service-name>:auth context of the CLI.

After you run the vsa-topology command, run the apply command to implement the changes.

vsa-topology enable | disable

Parameters

enable | disable Specifies to enable or disable the inclusion of Topology information in messages to the RADIUS server.

Usage

The vsa-topology command is not available when the authentication mode is guestportal. When the authentication mode is disabled, MAC must be enabled for this command to be available. For more information, see mode.

Example

The following example enables the inclusion of Topology information in messages to the RADIUS server:

EWC.extremenetworks.com:wlans:test:auth# vsa-topology enable
EWC.extremenetworks.com:wlans:test:auth# apply
EWC.extremenetworks.com:wlans:test:auth# show vsa-topology
Topology as VSA attribute: enable