platform

Use the platform command to specify the platform where the maintenance cycle is run.

After you run the platform command, run the apply command to implement the change.

platform [no|<platform>[,<platform>,...,<platform>]]

Parameters

no Removes all configured platforms.
platforms Identifies one or more platforms to be maintained.

Usage

Use the platform command to specify the platform for the maintenance cycle.

Supported platforms: AP3705, AP3710, AP3715, AP3765, AP3767, AP3801, AP3805, AP3825, AP3865, AP3935,AP3965, APVMAP, W78XC, W78XCSFP
Note

Note

The platform list may be vary on controllers with different regulation license.

Example

The following example specifies the platform of the maintenance cycle:

EWC.extremenetworks.com: maintain_cycle# platform AP3935

The following example adds three platforms:

EWC.extremenetworks.com:maintain_cycle# platform AP3767,AP3801,AP3805
EWC.extremenetworks.com:maintain_cycle# show
Frequency: daily weekend
Platform: AP3767,AP3801,AP3805
Start Time: 00:00
Duration: 3

The following example removes all configured platforms:

EWC.extremenetworks.com:maintain_cycle# platform no
EWC.extremenetworks.com:maintain_cycle# show
Frequency: daily weekend
Platform:Start Time: 00:00
Duration: 3