show topology

Use the show topology command to display the IDs and names of IP interfaces.

show topology l3

Parameters

l3 Displays only topologies with an L3 configuration. The topologies are listed by index number.

Usage

You can identify an IP using its interface name or, for short, the identifier returned by the show topology l3 command. Interface name is the name of any topology with L3 configuration (Physical, Admin, B@AC or Routed).

Examples

The following example displays the output of the show topology command when run without additional parameters:
EWC.extremenetworks.com# show topology

Name                    Mode         L2:VlanId,port      L3:IP,GW,DHCP

Admin                   admin        N/A,Admin           192.168.4.37,192.168.4.11,N/A

esa0                    physical     545,esa0            10.109.0.1,10.0.0.2,none

esa1                    physical      -1,esa1            10.0.1.1,10.0.1.2,none

Bridged at AP untagged  b@ap          -1,N/A
Extreme-37Topology      b@ac          647,esa0           10.209.2.37,0.0.0.0,none
777                     b@ac          777,esa-1
649                     b@ac          649,esa-1
650                     b@ac          650,esa0

Topology global info:
Internal VLAN ID:  1
Multicast support:
disabled
The following example uses the show topology l3 command to obtain interface information for use with the ping or traceroute commands:
EWC.extremenetworks.com# show topology l3

Name                        Mode            L3:IP

1:Admin                     physical        192.168.4.37
2:esa0                      physical        10.0.0.1
3:esa1                      physical        10.0.1.1
4:Extreme-37Topology        b@ac            10.10.1.1
5:CNL-209-AAA:engineering   routed          172.22.2.1