foreign-range

Use the foreign-range command to configure the DHCP pool of addresses for a remote Wireless Appliance in a paired controller configuration. The foreign-range command is available from the topology:<named-topology>:l3: dhcp context of the CLI for b@ac and routed topologies. This command is visible only when mode is set to local. See mode.

foreign-range A.B.C.D A.B.C.D

Parameters

A.B.C.D Specifies the first IP address in the IP address range.
A.B.C.D Specifies the last IP address in the IP address range.

Example

The following example specifies the IP address range:

EWC.extremenetworks.com:topology:routed2:l3:dhcp# mode local
EWC.extremenetworks.com:topology:routed2:l3:dhcp# foreign-range 10.44.6.2 10.44.6.254