show routes

Use the show routes command to display the routing table or static routes of the Wireless Appliance.

show routes all | static

Parameters

all Displays the routing table.
static Displays the static routes.

Examples

The following example displays the routing table:
EWC.extremenetworks.com# show routes all
Dest Addr          Netmask            Gateway        Interface    RouteType    Status
0.0.0.0            0.0.0.0            10.7.0.2       esa0         Static       Active
10.7.0.0           255.255.255.0      None           esa0         Connected    Active
10.7.1.0           255.255.255.0      None           esa1         Connected    Active
127.0.0.0          255.0.0.0          None           lo           Kernel     Inactive
127.0.0.0          255.0.0.0          None           lo           Connected    Active
136.157.233.128    255.255.255.128    192.168.1.1    eth0         Kernel       Active
172.16.113.0       255.255.255.0      None           esa2         Connected    Active
172.16.114.0       255.255.255.0      None           esa3         Connected    Active
172.16.117.0       255.255.255.128    None           esa5         Connected    Active
172.16.117.128     255.255.255.128    None           esa6         Connected    Active
172.16.118.0       255.255.255.192    None           esa7         Connected    Active
172.16.118.64      255.255.255.192    None           esa8         Connected    Active
172.16.118.128     255.255.255.192    None           esa9         Connected    Active
172.16.118.192     255.255.255.192    None           esa4         Connected    Active
172.16.125.0       255.255.255.0      None           esa10        Connected    Active

The following example displays the static routes on the Wireless Appliance:

EWC.extremenetworks.com# show routes static
RouteID    Dest Addr    Netmask    Next Hop    Interface    OverrideDynamic
1          0.0.0.0      0.0.0.0    10.7.0.2    1            on