mode

Use the mode command to set the DCS mode. The mode command is accessible from all ap: radio dcs contexts of the CLI.

In monitor mode, DCS generates an alarm, but does not change the channel, even if the noise and interference levels on the current channel exceed their thresholds. In active mode, generates an alarm and changes the channel if the noise and interference levels on the current channel exceed their thresholds.

mode monitor | active

Parameters

monitor Monitors the noise and interference on the current channel
active Enables DCS

Example

The following example sets DCS to active mode:

EWC.extremenetworks.com:ap:defaults:ap37xx:radio1:dcs# mode active