lldp

Use the lldp command to enable the broadcast of the LLDP protocol by a Wireless AP. Use the no form of the command to disable LLDP. The lldp command is accessible from the ap:<serial> and all ap:defaults contexts of the CLI.

lldp Announcement Interval Announcement Delay | no lldp

Parameters

Announcement Interval Specifies the scheduled frequency, measured in seconds, in which the Wireless AP advertises its information by sending a new LLDP packet. Range is 5 to 32768.
Announcement Delay Specifies the delay, measured in seconds, between successive LLDP frame transmissions that is initiated by a value/status change in the LLDP local systems MIB. Range is 1 to 1/4 x Announcement Interval value.

Examples

The following example enables LLDP for the default Wireless AP configuration with an announcement interval of 30 seconds, and an announcement delay of 2:

EWC.extremenetworks.com:ap:defaults:3935FCC# lldp 30 2

If SNMP is enabled to publish on the Wireless Appliance and you enable LLDP, the following message is displayed:

WARNING: SNMP is set to publish. How Do you wish to continue?
(C) Cancel
(P) Proceed
(O) Disable SNMP publishing and proceed

Type one of the following:

  • C – Cancels the LLDP configuration and returns to the AP context.
  • P – Enables LLDP and maintains SNMP running
  • O – Enables LLDP and disables SNMP publishing