Use the poll_timeout command to set the amount of time the Wireless AP waits for a response from the Wireless Appliance before rebooting. The poll_timeout command is accessible from the ap:<serial> and all ap:defaults contexts of the CLI.
After you run the poll_timeout command, run the apply command to implement the change in poll timeout value.
| value | Specifies the amount of time, in seconds, to wait for a response from the Wireless Appliance before rebooting. The range for poll_timeout value is from 3 to 600 unless the controller is in an availability pair without fast failover enabled. |
The following example sets the poll timeout to 20 seconds:
EWC.extremenetworks.com:ap:defaults:ap3801# poll_timeout 20
Print
this page
Email this topic
Feedback
View PDF
Download EPUB