mode

Use the mode command to change the mode of an existing b@ac, b@ap, or routed topology. You can configure the mode of a topology only if the topology is not associated with a policy. The mode command is available from the topology:<named-topology> context of the CLI for b@ac, b@ap, and routed topologies.

mode b@ap | b@ac | routed

Parameters

b@ap | b@ac | routed Specifies the mode of the topology.

Example

The following example changes the mode of the topology to b@ap:

EWC.extremenetworks.com:topology:bridged_ac1# mode b@ap