vsa-vns

Use the vsa-vns command to include VNS information in the message to the RADIUS server. The vsa-vns command is accessible from the wlan:<WLAN-service-name>:auth context of the CLI.

After you run the vsa-vns command, run the apply command to implement the changes.

vsa-vns enable | disable

Parameters

enable | disable Specifies to enable or disable the inclusion of VNS information in messages to the RADIUS server.

Usage

The vsa-vns command is not available when the authentication mode is guestportal. When the authentication mode is disabled, MAC must be enabled for this command to be available. For more information, see mode.

Example

The following example enables the inclusion of VNS information in messages to the RADIUS server:

EWC.extremenetworks.com:wlans:test:auth# vsa-vns enable
EWC.extremenetworks.com:wlans:test:auth# apply
EWC.extremenetworks.com:wlans:test:auth# show vsa-vns
VNS as VSA attribute: enable