show

Use the show command from the wlans context to display WLAN service configuration information.

show [WLANS-name]

Parameters

WLANS-name Specifies to display information about the specific WLAN service

Usage

The Radio Mode field displays the 802.11 modulations that the AP‘s radios are configured to use.

Examples

The following example displays a list of all WLAN service configuration information:
EWC.extremenetworks.com:wlans# show
Name  Service Type  Enabled  SSID  Privacy  Auth Mode  Radio Mode

osu   std           enabled  osu   none     disabled   off
hs    std           enabled  hs    wpa      8021x      off
std   std           enabled  std   none     internal   off
The following example displays configuration information for the WLAN service named “hs”:
EWC.extremenetworks.com:wlans# show hs
Service type: std
Hotspot type: enabled
Name: hs
Enable/disable WLAN Service: enable
Remotable: disable
Inter-WLAN Service Roaming: enable
Associated WLANs: hs
Egress Filtering: disable
Radio1  Radio2  AP Name
                3705i
                3805i
                ap3935i
                3965
                3805e
                ap3805i3
                3825i1
                ap3935e
SSID: hs
Default topology:
Pre-authentication timeout(minutes): 5
Post-authentication timeout(minutes): 30
Session timeout(minutes): 0
Enable/disable block MU to MU traffic: disable
Default CoS: No CoS
Default Traffic Mirror: prohibited
Enable/disable Netflow support: disable
Unauthenticated Behavior: discard-unauth-traffic
Radio Mode: off