sgname

Use the sgname command to create a scan group. Use the no form of the command to delete the scan group. The sgname command is accessible from the mitigator:scgroup context of the CLI.

After you add the Wireless APs to the scan group, run the apply command to implement the changes.

sgname scan group name 10-120 [dtime 200-5000] [radio1 |radio2|both] [channel all|current] [type active|passive] [serial serial...]
no sgname scan group name

Parameters

scan group name Specifies the scan group name
10-120 Specifies the scan time interval
dtime 1-1000 Specifies the Channel Dwell Time of the scan group
radio1 | radio2 | both Specifies radios — radio 1, radio 2, or both
channel all | current Specifies the channels to be scanned — all or current
type active | passive Specifies the scan type — active or passive
serial Specifies to add the Wireless APs by their serial numbers to the scan group.
serial Specifies the serial number of the Wireless APs that are to be added to the scan group

Example

The following example creates a scan group named South-Block:

EWC.extremenetworks.com:mitigator:scgroup# sgname South-Block 100 dtime 300 radio both channel all type active serial 0500006072051354 0500006072051427 0500006062051048 0500006062051040