Displaying MLD snooping tracing information
About this task
Use this procedure to display MLD snooping tracing information.
Procedure
Example
Switch:1#show ipv6 mld snoop-trace
============================================================
Mld Snoop Trace - GlobalRouter
============================================================
GROUP/
SOURCE IN IN OUT OUT TYPE
ADDRESS VLAN PORT VLAN PORT
------------------------------------------------------------
ff10:0:0:0:0:0:0:1/ 10 2/15 10 3/16 ACCESS
5051:0:0:0:0:1:84:51
Job Aid
The following table describes the column headings in the command output for show ipv6 mld snoop-trace.
|
Variable |
Description |
|---|---|
|
GROUP ADDRESS |
Specifies the IP multicast address of the group traversing the router |
|
SOURCE ADDRESS |
Specifies the IP source address of the multicast group address. |
|
IN VLAN |
Specfies the ingress VLAN ID for the multicast source. |
|
IN PORT |
Specifies the ingress port for the multicast group. |
|
OUT VLAN |
Specifies the egress VLAN ID for the multicast group. |
|
OUT PORT |
Specifies the egress port of the multicast group. |
|
TYPE |
Specifies the port type on which the snoop entry is learnt. |