Configuring the MLD last listener query interval

About this task

Use this procedure to configure the last listener query interval in seconds for the MLD interface.

Procedure

  1. Enter Interface Configuration mode:

    enable

    configure terminal

    interface GigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]} or interface vlan <1–4059>

    Note

    Note

    If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

  2. Configure the last listener query interval:

    ipv6 mld last-listener-query-interval <0-60>

  3. Set the last listener query interval to its default value:

    default ipv6 mld last-listener-query-interval

Variable definitions

The following table describes the variables for the ipv6 mld last-listener-query-interval command.

Variable

Description

<0–60>

Indicates the last listener query interval in seconds.