Graphing IS-IS Interface Receiving Control Packet Statistics

Use the following procedure to graph IS-IS interface sending control packet statistics.

Procedure

  1. In the navigation pane, expand the Configuration > IS-IS folders.
  2. Click IS-IS.
  3. Click the Interfaces tab.
  4. Select an existing interface.
  5. Click the Graph button.
  6. Click the Interface Receiving Control Packets tab.

Interface Receiving Control Packets Field Descriptions

The following table describes the fields in the Interface Receiving Control Packets tab.

Name

Description

Hello

Indicates the number of IS-IS Hello PDUs seen in this direction at this level. Point-to-Point IIH PDUs are counted at the lowest enabled level: at L1 on L1 or L1L2 circuits, and at L2 otherwise.

LSP

Indicates the number of IS-IS link-state packet (LSP) frames seen in this direction at this level.

CSNP

Indicates the number of IS-IS Complete Sequence Number Packet (CSNP) frames seen in this direction at this level.

PSNP

Indicates the number of IS-IS Partial Sequence Number Packets (PSNPs) seen in this direction at this level.

AbsoluteValue

Displays the counter value.

Cumulative

Displays the total value since you opened the Stats tab.

Average/Sec

Displays the average value for each second.

Minimum/Sec

Displays the minimum value for each second.

Maximum/Sec

Displays the maximum value for each second.

Last Val/Sec

Displays the last value for each second.