Static source groups

Use the show ip mroute static-source-group command to display information about the static source groups. You can see all the valid entries that were created. If an entry is created with a x bit mask, it shows as a x bit in the output. The syntax for this command is as follows.

show ip mroute static-source-group [<A.B.C.D>][vrf WORD <0–32>][vrfids WORD <0–255>]

Note

Note

This command is not supported on a node configured as the DvR Leaf within a DvR domain.

The following table shows the field descriptions for this command.

Table 1. show ip mroute static-source-group command

Field

Description

Group Address

Indicates the IP multicast group address.

Source Address

Indicates the network address.

Subnet Mask

Indicates the network mask.