Authentication for Privileged EXEC Command Mode

Table 1. Authentication for Privileged EXEC Mode product support
Feature	Product	Release introduced
For configuration details, see VOSS User Guide.
Authentication for Privileged EXEC CLI Command Mode	5520 Series	VOSS 8.2.5
	VSP 4450 Series	VOSS 8.2
	VSP 4900 Series	VOSS 8.2
	VSP 7200 Series	VOSS 8.2
	VSP 7400 Series	VOSS 8.2
	VSP 8200 Series	VOSS 8.2
	VSP 8400 Series	VOSS 8.2
	VSP 8600 Series	VSP 8600 8.0
	XA1400 Series	VOSS 8.2

For enhanced security, you can enable user authentication to enter Privileged EXEC command mode. Use the sys priv-exec-password command to enable password authentication.

After you enable password authentication for Privileged EXEC command mode, the system prompts you to enter a password to access Privileged EXEC command mode from User EXEC command mode. You must enter the same password that you used to log on to the switch.

Considerations

The same username and password used to Telnet or SSH to the switch is used to access Privileged EXEC command mode when authentication is enabled.
RADIUS and TACACS+ protocols are supported. If RADIUS and TACACS+ servers are not reachable, access to Privileged EXEC command mode is denied. You must open a new session and type the same username and password used to Telnet or SSH to the switch.
No timeout exists for the password used to log on to the Privileged EXEC command mode.
No limit to the number of retries if you enter an incorrect password.
VSP 8600 Series authentication for Priviledged EXEC command mode only allows HA support in hot-standby mode.