Display Auto-sense Configuration on the Switch

Note

Note

This procedure does not apply to VSP 8600 Series and XA1400 Series.

About this task

Perform this procedure to display the Auto-sense configuration on the switch.

Procedure

  1. To enter User EXEC mode, log on to the switch.
  2. Display the Auto-sense configuration:

    show auto-sense [access-differv] [data] [eapol] [fa] [isis] [onboarding] [qos] [voice]

  3. Display the Auto-sense status and state on a port:

    show interfaces gigabitEthernet auto-sense [{slot/port[/sub-port][-slot/port[/sub-port]][,...]}]

Examples

Display the Auto-sense configuration related to voice:

Switch:1>show auto-sense voice
===============================================================================
                              AUTO-SENSE VOICE Config
===============================================================================
I-SID      C-VID      DSCP       PRIORITY
-------------------------------------------------------------------------------
2000       2000       46         6
-------------------------------------------------------------------------------
1 out of 1 Total Num of AUTO-SENSE entries displayed
-------------------------------------------------------------------------------

Display the Auto-sense status and state on a range of ports:

Switch:1>#show interfaces gigabitethernet auto-sense 1/1-1/5
====================================================================================================
                                Port Auto-sense
====================================================================================================
----------------------------------------------------------------------------------------------------
PORT     AUTO-SENSE   AUTO-SENSE
NUM      STATUS       STATE
----------------------------------------------------------------------------------------------------
1/1      Enable       UNI-ONBOARDING
1/2      Disable      OFF
1/3      Disable      OFF
1/4      Disable      OFF
1/5      Disable      OFF