Use this procedure on a VOSS switch to change the Network Operating System (NOS) personality.The following table defines parameters for the software command.

Change the Network Operating System Personality

Use this procedure on a VOSS switch to change the Network Operating System (NOS) personality.

The primary method to select a NOS personality for the switch is by using ExtremeCloud IQ. If the network is not accessible, or if you do not use Extreme Networks management software, you can change the NOS personality by using VOSS CLI commands.

Before you begin

Use FTP to transfer the NOS image to the /intflash/ directory in the VOSS file system.

About this task

If you change the NOS personality, the system deletes all configuration, licensing, and log files that pertain to the previous NOS personality.

If a power interruption occurs during a personality change, the system restarts the process after you restore power to the switch.

As part of the NOS personality change, you must restart the switch. If, during the restart, the system detects a failure, the NOS personality does not change. After the original NOS restarts, it logs an error message and raises a persistent alarm.

Procedure

  1. Enter Privileged EXEC mode:

    enable

  2. Unpack the NOS image:

    software add WORD<1-99>

  3. Install the NOS image:

    software activate WORD<1-99>

  4. Confirm you want to change the NOS personality by entering Y.
  5. Confirm the new image has been added and will become active after the next restart:

    show software

    Important

    Important

    If you decide not to change the NOS personality, before you restart the switch, you can run the software activate command again with the primary release as the image name and the system cancels the NOS personality change.

  6. Restart the switch.

Example

Change the NOS personality to ExtremeXOS.
5520-24W-VOSS:1>enable
5520-24W-VOSS:1#software add summit_arm-31.1.0.540.xos
EXOS image validated successfully
Adding EXOS software - /intflash/summit_arm-31.1.0.540.xos
Extraction of /intflash/summit_arm-31.1.0.540.xos to /intflash/release/summit_arm-31.1.0.540.xos successful
5520-24W-VOSS:1#show software 
=============================================================================
                    software releases in /intflash/release/
=============================================================================
summit_arm-31.1.0.540.xos
5520.v8.2.5int030 (Primary Release)

-----------------------------------------------------------------------------
Auto Commit     : enabled
Commit Timeout  : 10 minutes
5520-24W-VOSS:1#software activate summit_arm-31.1.0.540.xos
Executing software activate for version summit_arm-31.1.0.540.xos.
Validated EXOS software
WARNING: The specified image is for the EXOS Network Operating System and the VOSS Network Operating System
is currently running.
If you continue, all data including configurations, logs and debugs will be cleared, except for the license activation
status. EXOS will be installed and VOSS image files will be removed.  Do you want to continue (y/n) ?y

Variable Definitions

The following table defines parameters for the software command.

Variable Value

activate WORD<1-99>

Specifies the software version to copy to the boot flash file.

add WORD<1-99>

Specifies the software version to unpack.