Enabling Remote Monitoring on an Interface

1. Enter Global Configuration mode:

   enable

   configure terminal

2. Enable RMON on a particular VLAN:

   vlan rmon <1-4059>

3. Enter GigabitEthernet Interface Configuration mode:

   enable

   configure terminal

   interface GigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]}

   

   Note

   If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

4. Enable RMON on a particular port:

   rmon

Example

Enable RMON on VLAN 2:

Switch:1>enable
Switch:1#configure terminal
Switch:1(config)#vlan rmon 2

Enable RMON on port 3/8:

Switch:1>enable
Switch:1#configure terminal
Switch:1(config)#interface gigabitethernet 3/8
Switch:1(config-if)#rmon