IGMP snoop

Use the show ip igmp snooping command to display the status of IGMP snoop. The syntax of this command is as follows.

show ip igmp snooping [vrf WORD <0-16>] [vrfids WORD <0-512>]

Note

Note

This command is not supported on a node configured as the DvR Leaf within the DvR domain.

The following table shows the field descriptions for this command.

Table 1. show ip igmp snooping command

Field

Description

IFINDEX

Indicates the interface index number.

SNOOP ENABLE

Indicates the status of IGMP snoop.

PROXY SNOOP ENABLE

Indicates the status of IGMP proxy snoop.

SSM SNOOP ENABLE

Indicates the status of IGMP Source Specific Multicast (SSM) snoop.

STATIC MROUTER PORTS

Indicates the set of ports in this VLAN that provide connectivity to an IP multicast router.

ACTIVE MROUTER PORTS

Indicates the active ports.

MROUTER EXPIRATION TIME

Indicates the multicast querier router aging timeout in seconds.

SNOOP QUERIER ENABLE

Indicates if the IGMP Layer 2 Querier feature is enabled.

SNOOP QUERIER ADDRESS

Indicates the IP address of the IGMP Layer 2 querier.

DYNAMIC DOWNGRADE VERSION

Indicates if the switch downgrades the version of IGMP to handle older query messages.

COMPATIBILITY MODE

Indicates if IGMPv3 is compatible with IGMPv2