Viewing SLPP Guard status

1. To enter User EXEC mode, log on to the switch.
2. Display SLPP Guard status:

   show slpp-guard {slot/port[/sub-port] [-slot/port[/sub-port]] [,...]}

Example

Switch:1#>show slpp-guard

========================================================================================
                                   SLPP Guard
========================================================================================
                          SLPP-guard Ethertype:   0x8102
=======================================================================================
                                 Port Interface
========================================================================================
Port       Link       Oper       SLPP-guard State      Timeout   TimerCount
----------------------------------------------------------------------------------------
1/1        Up         Down       Disabled   N/A        60        N/A
1/2        Up         Down       Enabled    N/A        120       N/A
1/3        Up         Up         Enabled    Monitoring 60        N/A
1/4        Up         Down       Enabled    N/A        120       N/A
1/5        Down       Down       Disabled   N/A        60        N/A
1/6        Down       Down       Disabled   N/A        60        N/A
1/7        Down       Down       Disabled   N/A        60        N/A
1/8        Down       Down       Disabled   N/A        60        N/A
1/9        Down       Down       Disabled   N/A        60        N/A
1/10       Down       Down       Disabled   N/A        60        N/A
1/11       Down       Down       Disabled   N/A        60        N/A
1/12       Down       Down       Disabled   N/A        60        N/A

Note

The TimerCount column in the preceding example output indicates the time, in seconds, that elapses after SLPP Guard disables a port. When the value TimerCount value equals the Timeout value, the switch re-enables the port.