Save Running Configuration to a File

About this task

Perform this procedure to save the current configuration on Fabric IPsec Gateway Virtual Machine (VM) to a specific file.

Procedure

  1. Enter Fabric IPsec Gateway Configuration mode:

    enable

    virtual-service WORD<1-128> console

    Note

    Note

    Type CTRL+Y to exit the console.

  2. Save configuration to the default configuration file:

    save config

  3. Save configuration to a specific file in the Fabric IPsec Gateway VM.

    save config file WORD <1-255>

Example

Saving configuration of Fabric IPsec Gateway VM to file "test":
Switch:1> enable
Switch:1# virtual-service figw console
Connected to domain figw
Escape character is ^Y

  <cr>
FIGW> save config file test

Variable Definitions

The following table defines parameters for the save config command.

Variable Value
file WORD <1-255> Specifies the name of file to save the configuration of the Fabric IPsec Gateway VM.
9036830-00 Rev AD