Viewing IP routes

View IP routes learned on the device.

Procedure

In the navigation pane, expand the following folders: Configuration > IP.
Click IP.
Click the Routes tab to view IP routes learned on the device.
If you want to limit the routes displayed, click Filter to show a smaller subset of the learned routes.
In the Filter dialog box, select an option, or options, and enter information to limit the routes to display in the Routes table.
Click Filter and the Routes table displays only the routes that match the options and information that you enter.

Routes field descriptions

Use the data in the following table to use the Routes tab.


Name	Description
Dest	Specifies the destination IP network of this route. An entry with a value of 0.0.0.0 is a default route. Multiple routes to a single destination can appear in the table, but access to multiple entries depends on the table access mechanisms defined by the network management protocol in use.
Mask	Indicates the network mask to logically add with the destination address before comparison to the destination IP network.
NextHop	Specifies the IP address of the next hop of this route.
AltSequence	Indicates the alternative route sequence. The value of 0 denotes the best route.
NextHopId	Displays the MAC address or hostname of the next hop.
HopOrMetric	Displays the primary routing metric for this route. The semantics of this metric are specific to different routing protocols.
Interface	Specifies the router interface for this route. Virtual router interfaces are identified by the VLAN number of the VLAN followed by the (VLAN) designation. Brouter interfaces are identified by the slot and port number of the brouter port.
Proto	Specifies the routing mechanism through which this route was learned: other—none of the following local—nonprotocol information, for example, manually configured entries static ICMP EGP GGP Hello RIP IS-IS ES-IS Cisco IGRP bbnSpfIgp OSPF BGP Inter-VRF Redistributed Route
Age	Displays the number of seconds since this route was last updated or otherwise determined to be correct.
PathType	Indicates the route type, which is a combination of direct, indirect, best, alternative, and ECMP paths. iA indicates Indirect Alternative route without an ECMP path iAE indicates Indirect Alternative ECMP path iB indicates Indirect Best route without ECMP path iBE indicates Indirect Best ECMP path dB indicates Direct Best route iAN indicates Indirect Alternative route not in hardware iAEN indicates Indirect Alternative ECMP route not in hardware iBN indicates Indirect Best route not in hardware iBEN indicates Indirect Best ECMP route not in hardware dBN indicates Direct Best route not in hardware iAU indicates Indirect Alternative Route Unresolved iAEU indicates Indirect Alternative ECMP Unresolved iBU indicates Indirect Best Route Unresolved iBEU indicates Indirect Best ECMP Unresolved dBU indicates Direct Best Route Unresolved iBF indicates Indirect Best route replaced by FTN iBEF indicates Indirect Best ECMP route replaced by FTN iBV indicates Indirect best IPVPN route iBEV indicates Indirect best ECMP IP VPN route iBVN indicates Indirect best IP VPN route not in hardware iBEVN indicates Indirect best ECMP IP VPN route not in hardware
Pref	Displays the preference.
NextHopVrfId	Specifies the VRF ID of the next-hop address.