Configure Layer 2 Trusted Auto-sense Ports

Note

Note

This procedure does not apply to VSP 8600 Series and XA1400 Series.

About this task

Perform this procedure to override incoming 802.1p bits on ports that operate in Auto-sense mode.

Procedure

  1. Enter Global Configuration mode:

    enable

    configure terminal

  2. Configure Auto-sense ports as Layer 2 untrusted:

    auto-sense qos 802.1p-override

Example

Configure Auto-sense ports as Layer 2 trusted:

Switch:1>enable
Switch:1#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch:1(config)#auto-sense qos 802.1p-override