Configure Auto-sense Access Ports

Note

This procedure does not apply to VSP 8600 Series and XA1400 Series.

About this task

Perform this procedure to configure ports operating in Auto-sense mode to determine the Layer 3 QoS actions the switch performs. The Auto-sense access ports override the Differentiated Services Code Point (DSCP) markings.

Procedure

Enter Global Configuration mode:

enable

configure terminal
Configure Auto-sense access ports:

auto-sense access-diffserv [enable]

Example

Configure the Auto-sense access ports:

Switch:1>enable
Switch:1#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#auto-sense access-diffserv enable

Variable Definitions

The following table defines parameters for the auto-sense access-diffserv command.


Variable	Value
enable	Configures the ports operating in Auto-sense mode to determine the Layer 3 QoS actions the switch performs. The Auto-sense access ports override the Differentiated Services Code Point (DSCP) markings. The default configuration is enabled.