Use the show ip mroute hw-resource-usage command to display information about the hardware resource use of an IP multicast route.
Note
This command is not supported on a node configured as the DvR Leaf within a DvR domain.
The syntax for this command is as follows:
show ip mroute hw-resource-usage [vrf WORD <0–32>] [vrfids WORD <0–255>]
|
Field |
Description |
|---|---|
|
EGRESS REC IN-USE |
Displays the number of egress records traversing the switch. |
|
INGRESS REC IN-USE |
Displays the number of ingress records (source or group) traversing the switch. |
|
EGRESS THRESHOLD |
Displays the configured egress threshold level (0–32767). A notification message is sent if this value is exceeded. The default is 0. |
|
INGRESS THRESHOLD |
Displays the configured ingress threshold level (0–32767). A notification message is sent if this value is exceeded. The default is 0. |
|
LOG MSG ONLY |
Displays whether only log notification messages are sent after the threshold level is exceeded. The default is false (disabled). |
|
SEND TRAP ONLY |
Displays whether only trap notification messages are sent after the threshold level is exceeded. The default is false (disabled). |
|
SENT TRAP AND LOG |
Displays whether both trap and log notification messages are sent after the threshold level is exceeded. The default is false (disabled). |