Enabling PIM on a CLIP interface

Enable Protocol Independent Multicasting (PIM) on a CLIP interface so that it can participate in PIM routing.

Before you begin

  • You must globally enable PIM.

About this task

Note

Note

The PIM button does not appear for all hardware platforms.

Procedure

  1. In the navigation tree, expand the following folders: Configuration > IP.
  2. Click IP.
  3. Click the Circuitless IP tab.
  4. Select the required CLIP interface.
  5. Click PIM.
  6. Select the Enable check box.

    You must enable PIM on the CLIP interface for PIM to function. The mode is indicated on this tab.

  7. Click Apply.

Circuitless PIM field descriptions

Use the data in the following table to use the Circuitless PIM tab.

Name

Description

Enable

Enables PIM on the CLIP interface.

Mode

Specifies the PIM mode.

9036830-00 Rev AD