Configure the IPFIX Aging Interval
About this task
Use the following procedure to configure an aging interval for IPFIX. The aging interval determines how long a traffic flow that is no longer being received, is retained as a flow.
Procedure
Example
Switch:1>enable Switch:1#configure terminal Enter configuration commands, one per line. End with CNTL/Z. Switch:1(config)#ip ipfix aging-interval 30
Variable Definitions
The following table defines parameters for the ip ipfix aging-interval command.
|
Variable |
Value |
|---|---|
|
aging-interval <interval> |
Specifies (in seconds) the flow record aging interval. The aging interval determines how long a traffic flow that is no longer being received is retained as a flow. Depending on the hardware platform, the parameter range and default value can vary. Use the CLI Help to see the available range for the switch. The default varies depending on the platform:
|