View License File Information

About this task

View information about the license file for the switch.

Procedure

In the navigation pane, expand Configuration > Edit.
Click Chassis.
Click the License tab.

License field descriptions

Use the data in the following table to use the License tab.


Name	Description
FileName	Indicates the file name of the current license. Note: If this field is empty it indicates that there is no license installed on the switch.
LicenseType	Indicates the level type of the current license.
DurationType	Indicates the duration type of the current license.
RemainingDays	Indicates the days left before the factory default trial period or subscription license expires. Note: For other license types, the field displays 0.
GenerationTime	Indicates the date on which the license file was generated. Note: If there is no license installed on the system, this field displays 0000000000000000 H.
ExpirationTime	Indicates the date on which the license file expired. Note: If there is no license installed on the system, this field displays 0000000000000000 H.

System Field Descriptions

Use the data in the following table to use the System tab.


Name	Description
sysDescr	Shows the system assigned name and the software version.
sysUpTime	Shows the elapsed time since the system last started.
sysContact	Configures the contact information.
sysName	Configures the name of this device.
sysLocation	Configures the physical location of this device.
VirtualIpAddr	Configures the virtual IP address that the primary CPU advertises and stores in the switch configuration file.
VirtualNetMask	Configures the net mask of the virtual management IP address.
VirtualIpv6Addr	Specifies the virtual IPv6 address.
VirtualIpv6PrefixLength	Specifies the length of the virtual IPv6 address prefix (in bits).
DnsDomainName	Configures the default domain for querying the DNS server.
LastChange	Displays the time since the last configuration change.
LastVlanChange	Displays the time since the last VLAN change.
LastStatisticsReset	Displays the time since the statistics counters were last reset.
LastRunTimeConfigSave	Displays the last run-time configuration saved.
DefaultRuntimeConfigFileName	Displays the default Run-time configuration file directory name.
ConfigFileName	Specifies the name of a new configuration file.
ActionGroup1 Note: Exception: revokeLicensePremier and revokeLicenseMacsec only supported on the 5520 Series.	Can be one of the following actions: resetCounters—resets all statistic counters saveRuntimeConfig—saves the current run-time configuration loadLicense—Loads a software license file to enable features revokeLicensePremier—Revokes the Premier license and generates a revocation certificate in XML format revokeLicenseMacsec—Revokes the MACsec license and generates a revocation certificate in XML format
LicenseFileName Note: Exception: only supported on the 5520 Series, VSP 8600 Series, and the XA1400 Series.	Specifies the name of the license file when copied to the flash. The destination file name must meet the following requirements: Maximum of 63 alphanumeric characters No spaces or special characters allowed Underscore (_) is allowed The file extension ".xml" is required
ActionGroup2	Specifies the following action: resetlstStatCounters—Resets the IST statistic counters
ActionGroup3	Can be the following action: flushIpRouteTbl—flushes IP routes from the routing table
ActionGroup4	Can be the following action: softReset—resets the device without running power-on tests cpuSwitchOver—switches over to the other CPU softResetCoreDump —reset with coredump
Result	Displays a message after you click Apply.
LocatorLED Note: Exception: only supported on 5520 Series and VSP 4900 Series.	Configures the system Locator LED on or off. The default is off.