Delete IPsec Tunnel Configuration on Fabric IPsec Gateway VM

About this task

Perform this procedure to delete the configuration of specific IPsec tunnel on Fabric IPsec Gateway Virtual Machine (VM).

Procedure

Enter Fabric IPsec Gateway Configuration mode:

enable

virtual-service WORD<1-128> console

Note

Type CTRL+Y to exit the console.
Delete the configuration of specific IPsec tunnel:

delete ipsec <1-255> <admin-state enable | auth-key | encryption-key-length | fe-tunnel-dest-ip | ipsec-dest-ip | mtu | responder-only | tunnel-name>

Example

Deleting the authentication key and tunnel name configured on IPsec tunnel with ID 2:

Switch:1> enable
Switch:1# virtual-service figw console
Connected to domain figw
Escape character is ^Y

  <cr>
FIGW> delete ipsec 2 auth-key
FIGW> delete ipsec 2 tunnel-name

Variable Definitions

The following table defines parameters for the delete ipsec command.


Variable	Value
`<1-255>`	Specifies the unique ID of the configured IPsec tunnel.
admin-state `enable`	Disables the IPsec status on the specific IPsec tunnel.
auth-key	Deletes the authentication key that you configure on the specific IPsec tunnel.
encryption-key-length	Resets the encryption key length for the specific IPsec tunnel to its default value, that is 128 bit.
fe-tunnel-dest-ip	Deletes the destination IP address that you configure on the Fabric Extend (FE) tunnel.
ipsec-dest-ip	Deletes the destination IP address that you configure on the IPsec tunnel.
mtu	Resets the Maximum Transmission Unit (MTU) value for the specific IPsec tunnel to the MTU value configured globally.
responder-only	Deletes the mode that you configure for the IPsec session in FE tunnel.
tunnel-name	Deletes the name that you configure for the IPsec tunnel.