Configure IPv4 Static Routes for a Management VLAN

Note

Note

This procedure does not apply to VSP 8600 Series.

Use this task to configure static routes for the management VLAN.

Procedure

  1. In the navigation pane, expand Configuration > Edit.
  2. Expand Mgmt Instance.
  3. Select Mgmt.
  4. Select the IpStaticRoute tab.
  5. Select Insert.
  6. For the Instance, select vlan.
  7. Type the destination IP address and mask.
  8. Type the next hop IP address.
  9. Type a metric value.
  10. Select Insert.

IpStaticRoute Field Descriptions

Use the data in the following table to use the IpStaticRoute tab.

Name

Description

Instance

Specifies the Management Instance.

DestAddr

Specifies the destination IP address.

DestMask

Specifies the destination mask.

NextHop

Specifies the next hop address for the static route.

Use an IP address in the same subnet as the management VLAN IP address.

IntfName

Specifies the Management Instance interface name for the route entry.

Metric

Specifies the static route cost. The default is 200.

The management CLIP uses an internal static route with a weight of 100. If you use both CLIP and VLAN and need to force all default traffic out the management VLAN interface, configure a default static route with a weight lower than 100.

State

Shows if the route is active or inactive.
9036830-00 Rev AD