local-endpoint-ip

Uses the configured IP as local tunnel endpoint address, instead of the interface IP (Advanced Configuration)

Supported on the following devices:

Access Points: AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP6522, AP6562, AP7161, AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP763, AP7662, AP8163, AP8543, AP8533.
Service Platforms: NX5500, NX7500, NX9500, NX9600
Virtual Platforms: CX9000, VX9000

local-endpoint-ip <IP>

local-endpoint-ip <IP>


local-endpoint-ip <IP>	Uses the configured IP as local tunnel‘s endpoint address <IP> – Specify the IP address. The specified IP address must be available on the interface.

nx9500-6C8809(config-profile-default-ap8533-cryptomap-map1#1)#local-endpoint-ip 172.16.10.3