fallback-channel

Configures the channel to which the radio switches in case of radar detection on the current channel

Supported in the following platforms:

Access Points — AP5010, AP310i/e, AP410i/e, AP460i/e, AP505i, AP510i/e, AP560i/h, AP7522, AP7532, AP7562, AP7612, AP7632, AP7662, AP8432, AP8533

Syntax

fallback-channel [100|100w|100ww|104|104w|104ww|108|108w...............74]

Parameters

fallback-channel [100|100w|100ww|104|104w|104ww|108|108w...............74]


fallback-channel [100\|100w\|...........]	Configures the fallback channel. This is the channel the radio switches to in case a radar is detected on the radio‘s current operating channel. [100\|100w\|100ww\|...] – Select the fall back channel from the available options.

Example

nx9500-6C8809(config-profile-testAP510-if-radio2)#fallback-channel 104
NOTE: Functionality is supported only in the US regulatory domain and only a non-dfs channel can be configured as a fallback channel

nx9500-6C8809(config-profile-testAP510-if-radio2)#show context
 interface radio2
  fallback-channel 104
nx9500-6C8809(config-profile-testAP510-if-radio2)#

Related Commands


no (radio-interface-config-command)	Removes the fallback-channel configuration