no

Negates a command or sets its default. When used in the RADIUS user pool policy mode, the no command deletes a user from a RADIUS user pool

Supported on the following devices:

Access Points: AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP6522, AP6562, AP7161, AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP763, AP7662, AP8163, AP8543, AP8533.
Service Platforms: NX5500, NX7500, NX9500, NX9600
Virtual Platforms: CX9000, VX9000

Syntax

no user <USERNAME>

Parameters

no user <USERNAME>


no user <USERNAME>	Deletes a RADIUS user <USERNAME> – Specify the user name.

Examples

The following example shows the RADIUS user pool ‘testuser‘ settings before the ‘no‘ command is executed:

nx9500-6C8809(config-radius-user-pool-wdws)#show context
radius-user-pool-policy wdws
 user guestuser1 password 0 guestuser@1 group wdws guest expiry-time 12:30 expiry-date 12/15/2014 access-duration  500
nx9500-6C8809(config-radius-user-pool-wdws)#

nx9500-6C8809(config-radius-user-pool-wdws)#no user guestuser1

The following example shows the RADIUS user pool ‘testuser‘ settings after the ‘no‘ command is executed:

nx9500-6C8809(config-radius-user-pool-wdws)#show context
radius-user-pool-policy wdws
nx9500-6C8809(config-radius-user-pool-wdws)#