local-ip-address

Configures the tunnel's source IP address. If no IP address is specified, the tunnel's source IP address is automatically configured based on the tunnel peer's IP address.

Supported on the following devices:

Access Points: AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP6522, AP6562, AP7161, AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP763, AP7662, AP8163, AP8543, AP8533.
Service Platforms: NX5500, NX7500, NX9500, NX9600
Virtual Platforms: CX9000, VX9000

Syntax

local-ip-address <IP>

Parameters

local-ip-address <IP>


local-ip-address <IP>	Configures the L2TPv3 tunnel‘s source IP address <IP> – Specify the tunnel‘s IP address. Ensure the IP address is available (or will become available - virtual IP) on an interface. Modifying a tunnel‘s local IP address re-establishes the tunnel.

Examples

nx9500-6C8809(config-profile default-nx5500-l2tpv3-tunnel-Tunnel1)#local-ip-address 172.16.10.2

nx9500-6C8809(config-profile default-nx5500-l2tpv3-tunnel-Tunnel1)#show context
 l2tpv3 tunnel Tunnel1
  local-ip-address 172.16.10.2
  hostname TunnelHost1
nx9500-6C8809(config-profile default-nx5500-l2tpv3-tunnel-Tunnel1)#

Related Commands


no	Resets the tunnel‘s local IP address and re-establishes the tunnel