The initial units of AP505 and AP510 model
access points have been shipped with a pre-production firmware version loaded. To get
these units operational, you will need to upgrade them to the official WiNG 7.1.0.0-138R
firmware version.
This chapter describes the procedure to be followed to upgrade 'Rev:
AA' AP505/AP510 model access points to the latest image.
How to
determine if your AP requires an upgrade?
To begin with, determine if your AP505/AP510 requires a software
upgrade. Check the label on the access point box for the
'Hardware Revision Version'. If the revision version reads 'Rev:
AA' the access point must be upgraded.
