channel-group

interface-config-ge-instance

Assigns this Ethernet port to a channel group. Ethernet ports can be aggregated to form a channel group. They can be aggregated to form a minimum of one and maximum of two channel groups. A port can be a member of only one channel group at a time.

Supported on the following devices:

Access Points: AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP6522, AP6562, AP7161, AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP763, AP7662, AP8163, AP8543, AP8533.
Service Platforms: NX5500, NX7500, NX9500, NX9600
Virtual Platforms: CX9000, VX9000

Syntax

channel-group <1-4>

Parameters

channel-group <1-4>


<1-4>	Specifies a channel group number from 1 - 4. The number of channel groups supported varies with the device type. For example: NX5500 – Supports three channel groups NX75XX – Supports four channel groups NX95XX – Supports two channel groups

Example

nx9500-6C8809(config-profile-testnx5500-if-ge1)#channel-group 1

nx9500-6C8809(config-profile-testnx5500-if-ge1)#show context
 interface ge1
  ip dhcp trust
  qos trust dscp
  qos trust 802.1p
  channel-group 1
nx9500-6C8809(config-profile-testnx5500-if-ge1)#

Related Commands


no	Removes the channel group to which this port belongs