adopter-auto-provisioning-policy-lookup

Profile Config Commands

Enables the use of a centralized auto provisioning policy on this profile. When enabled, the auto-provisioning policy applied on the NOC gets precedence over the one applied at the site controller level. Optionally, use the ‘evaluate-always‘ option to set flag to run centralized auto-provisioning policy every time a device (access point/controller) is adopted. The device‘s previous adoption status is not taken into consideration.

This command is also applicable in the device configuration context.

Supported on the following devices:

• Access Points: AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP6522, AP6562, AP7161, AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP763, AP7662, AP8163, AP8543, AP8533.
• Service Platforms: NX5500, NX7500, NX9500, NX9600
• Virtual Platforms: CX9000, VX9000

Syntax

adopter-auto-provisioning-policy-lookup {evaluate-always}

Parameters

adopter-auto-provisioning-policy-lookup {evaluate-always}

Examples

nx9500-6C8809(config-profile-test4K)#adopter-auto-provisioning-policy-lookup evaluate-always

nx9500-6C8809(config-profile-test4K)#show context include-factory | include adopter-auto-provisioning-policy-lookup
 adopter-auto-provisioning-policy-lookup evaluate-always
nx9500-6C8809(config-profile-test4K)#

Related Commands