root (meshpoint-device-config)

Configures this meshpoint device as the root meshpoint

You can optionally use the select-method option to enable dynamic mesh selection. When enabled, this option overrides root or no-root configuration and uses the selection method.

Supported in the following platforms:

Access Points — AP 6522, AP 6532, AP 6562, AP 7161, AP 7502, AP-7522, AP 7532, AP-7562, AP7632, AP7662, AP-8432, AP-8533

Syntax

root {select-method [auto-mint|auto-proximity]}

Parameters

root {select-method [auto-mint|auto-proximity]}


root	Configures this meshpoint device as the root meshpoint
select-method auto-mint]	Optional. Enables dynamic mesh selection. When enabled, this option overrides root or no-root configuration and chooses the selection method. auto-mint – Enables dynamic root selection using Auto-MiNT (based on path cost) The Auto-Mint or Cost Method dynamically determines the root/non-root configuration of a meshpoint by: Monitoring and ranking the signal strength and path cost of neighboring mesh points. Setting the configuration to: non-root: If the link with the shortest path to the cost-root mesh device is a MCX meshpoint link root: If the link with the shortest path to the cost-root mesh device is a non MCX meshpoint link (wired link). This requires that the meshpoint device, in the brain car, be configured as the ‘cost root‘ and the ‘cost root‘ meshpoint-device be the l2 gateway to the controller. Use the root-select > cost-root command to configure a meshpoint-device as ‘cost-root‘. Using signal strength of neighboring meshpoint as the sole metric to determine the next mesh hop to the root. Loop detection with both meshpoints in a car select non-root and form a mesh link with the same root
select-method auto-proximity	Enables dynamic root selection using meshpoint proximity. When auto-proximity is selected, root selection is based on signal strength of candidate roots.

Examples

nx9500-6C8809(config-profile-testAP8432-meshpoint-test)#root select-method  auto-mint

nx9500-6C8809(config-profile-testAP8432-meshpoint-test)#show context
 meshpoint-device test
  name test
  root select-method auto-mint
  preferred root 22-33-44-55-66-77
  preferred neighbor 11-22-33-44-55-66
  preferred interface 5GHz
  monitor critical-resource action no-root
nx9500-6C8809(config-profile-testAP8432-meshpoint-test)#

ap8432-070235(config-device-74-67-F7-07-02-35-meshpoint-test)#root select-method auto-mint

ap8432-070235(config-device-74-67-F7-07-02-35-meshpoint-test)#show context
 meshpoint-device test
  root select-method auto-mint
ap8432-070235(config-device-74-67-F7-07-02-35-meshpoint-test)#

Related Commands


no (meshpoint-device-config)	Removes the configuration of this meshpoint device as a root meshpoint. Also allows you to disable dynamic mesh selection (if enabled).