fallback

Enables fallback to destination-based routing. This option is enabled by default. To disable fallback, use the no → fallback command.

The action taken for packets satisfying the match criteria is determined by the mark (action) clauses. If no action is defined, the default is to fallback to destination-based routing.

Note

If no mark clause is configured and fallback to destination-based routing is disabled, then the packet is dropped.

Supported on the following devices:

Access Points: AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP6522, AP6562, AP7161, AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP763, AP7662, AP8163, AP8543, AP8533.
Service Platforms: NX5500, NX7500, NX9500, NX9600
Virtual Platforms: CX9000, VX9000

Syntax

fallback

Parameters

None

Examples

nx9500-6C8809(config-routing-policy-testpolicy-route-map-1)#fallback
nx9500-6C8809(config-routing-policy-testpolicy-route-map-1)#

Related Commands


no (route-map-config-mode-command)	Disables fallback to destination-based routing if no next hop is configured or are unreachable