peer

gre-config-instance

Adds the GRE tunnel‘s end-point peers. A maximum of two peers, representing the tunnel‘s end points, can be added for each GRE tunnel.

Supported on the following devices:

Access Points: AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP6522, AP6562, AP7161, AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP763, AP7662, AP8163, AP8543, AP8533.
Service Platforms: NX5500, NX7500, NX9500, NX9600
Virtual Platforms: CX9000, VX9000

Syntax

peer <1-2> ip <IPv4/IPv6>

Parameters

peer <1-2> ip <IPv4/IPv6>


peer <1-2> ip <IPv4/IPv6>	Configures the tunnel‘s end-point peers <1-2> – Specify a numeric index for each peer to help differentiate the tunnel end points. ip – Specify the IP address (IPv4/IPv6) of the added GRE peer to serve as a network address identifier. <IPv4/IPv6> – Specify the peer‘s IPv4 or IPv6 address.

Example

rfs4000-229D58(config-device 00-23-68-22-9D-58-gre-tunnel-testGRETunnel)#peer 1
ip 192.168.13.6

rfs4000-229D58(config-device 00-23-68-22-9D-58-gre-tunnel-testGRETunnel)#show context
 gre tunnel testGRETunnel
  peer 1 ip 192.168.13.6
  native tagged
  dscp 20
  failover interval 200 retry 5
rfs4000-229D58(config-device 00-23-68-22-9D-58-gre-tunnel-testGRETunnel)#

Related Commands


no	Removes the GRE tunnel settings based on the parameters passed