About this Guide

This manual describes how to use a Command Line Interface to deploy Extreme Networks access points, wireless controllers and platforms within a WiNG Controller managed network.

The WiNG Controller software supports the following access points, wireless controllers and platforms:

Universal access points (802.11ax) - AP302W, AP305C, AP305CX, AP410C, AP460C, AP460S6C, AP460S12C, AP5010
Access points (802.11ax) – AP360i, AP360e, AP310i, AP310e, AP410i, AP410e, AP460i, AP460e, AP560i, AP560h, AP510i, AP510e, AP505i
Access points (802.11ac) – AP7522, AP7532, AP7562, AP7612, AP7632, AP7662, AP8432, AP8533
Service platforms – NX5500, NX7500, NX9500, NX9600
Virtual platforms – CX9000, VX9000

For detailed product information about access points and platforms, refer to the relevant product documentation. See https://www.extremenetworks.com/support/documentation/.

See also Access Points Hardware and Firmware Specifications for a brief summary of access point specifications, including minimum firmware requirements.

The following sections describe the conventions used in this guide.