cdp
Profile Config Commands
Enables Cisco Discovery Protocol (CDP), a
proprietary data link layer network protocol implemented in Cisco networking equipment
and used to share network information amongst different vendor wireless devices
Supported on the following devices:
- Access Points: AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP6522, AP6562, AP7161, AP7502,
AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP763, AP7662, AP8163, AP8543,
AP8533.
- Service Platforms:
NX5500, NX7500, NX9500, NX9600
- Virtual Platforms: CX9000, VX9000
cdp [holdtime <10-1800>|run|timer <5-900>]
Parameters
cdp [holdtime <10-1800>|run|timer <5-900>]
| holdtime
<10-1800> |
Specifies the
holdtime after which transmitted packets are discarded
- <10-1800> – Specify
a value from 10 - 1800 seconds. The default is 180 seconds.
|
| run |
Enables CDP
sniffing and transmit globally. This feature is enabled by default. |
| timer
<5-900> |
Specifies the
interval, in seconds, between successive CDP packet transmission
- <5-900> – Specify a
value from 5 - 900 seconds. The default is 60 seconds.
|
Example
nx9500-6C8809(config profile-default-ap8533)#cdp run
nx9500-6C8809(config profile-default-ap8533)#cdp holdtime 1000
nx9500-6C8809(config profile-default-ap8533)#cdp timer 900
nx9500-6C8809(config-profile-default-ap8533)#show context
profile ap8533 default-ap8533
bridge vlan 1
no edge-vlan
l2-tunnel-broadcast-optimization
.............................................................
qos trust 802.1p
interface pppoe1
use firewall-policy default
cdp holdtime 1000
cdp timer 900
service pm sys-restart
router ospf
nx9500-6C8809(config-profile-default-ap8533)#
Related Commands
| no |
Disables CDP on this profile |
